Joel Berman Glass Studios

StudioTextured Colored GlassClient ListHardwareContact UsReturn to Home Page


 

Tactiles™ Specifications

Installation Specifications
Interior Applications
ma Kerapoxy (color #0, white)
100% solids epoxy mortar and grout system

Exterior Applications
Mapei Planicrete W to set
Mapei Ultracolor Grout - see specifier color selector or contact your local Mapei representative

Butt-Joint Application
Dow Corning Silicone Glazing Sealant #1199

Special Instructions
Back-buttering is recommended to ensure that an adequate bond is achieved. If the above mentioned products are not readily available in your area please contact is for a quotation to supply.

General Disclaimer
On handcrafted material such as TACTILES, variations in color, shade, surface texture and size may occur. Samples provided are representative only and may not show all characteristic variations. Please note that as all kiln-fired and painted glass is individually fired and handcrafted, slight differences, bubbles and mottled textures may occur and should not be considered defective. Joel Berman Glass Studios International Ltd. provides no warranty, expressed or implied, pertaining to the use or applicability of its product for any particular purpose. No consequential damages resultant from installation of its product will be assumed. The exclusive responsibility of Joel Berman Glass Studios International Ltd. will be to replace defective product without any cost of removal, replacement, or related costs, FOB the same point of destination to which the original product was supplied. The warranty applies only to the purchaser of the glass and the owner of the structure to which it is installed, provided adequate proof of purchase is furnished.

Orders for TACTILES are produced strictly on a made to order basis. No material is stocked. All orders and quantities are the sole responsibility of the Purchaser or their representatives.

A 50% deposit is required upon placement of an order. The order will be scheduled for production upon receipt of the required deposit. Both the Purchase Order and the deposit must be received prior to commencement of production. The balance of payment is due when the order is ready to ship. All payments must be in the form of a certified check, cashier’s check or wire transfer.

Back to top of page

 

 

Sizes
4" x 4" (10.2cm x 10.2cm)
12" x 12" (30.5cm x 30.5cm)
maximum 54" x 108" (137.2cm x 274.3cm)

Tactiles™ Textures
Tactiles™ Colors
Tactiles™ Specifications
© 2007 Joel Berman Glass Studios International. Site Credits.